Radio Shack PRO-2056 - Manual (Page 18)

18
PRIVATE — appears when you scan
the frequencies you stored in the PRI-
VATE bank’s channels.
POLICE , FIRE/EMG , AIR , MRN
— appear when you scan the preset
frequencies in the named service
search bank.
WX — appears when you scan the pre-
set weather frequencies.
HOLD — appears when you press
HOLD to stop scanning or searching.
SCAN — appears when you scan
channels until a frequency appears.
SRCH s or t — appears during a
search to show the search direction.
Search Band Range Numbers — ap-
pear instead of a frequency to show
which of the scanner’s 11 search
bands you selected.
L/O — appears when you lock out a
channel or frequency or manually se-
lect a locked-out channel or frequency
(see “Locking Out Channels and Fre-
quencies” on Page 23).
MEMO LOSS — appears when you first
turn on the scanner until you program
the scanner, and when you turn on the
scanner after a power loss when the
scanner’s memory backup circuit is
too weak to save the scanner’s pro-
gramming.
Error — appears when you make an
incorrect entry.
Prg-Loc — appears when you try to
program the scanner while
MEMOLOCK OFF/ON is set to ON (see
“Using Memolock” on Page 23).
CH — flashes when you program the
scanner.
Channel Number — appears on the
left side of the display to show which of
the scan bank channels the scanner is
tuned to.
The display has indicators that show the scanner’s operating mode. A good look at
the display will help you understand your scanner’s operation.
A LOOK AT THE DISPLAY
20-147.fm Page 18 Tuesday, August 3, 1999 3:23 PM