Configuring c series displays – Raymarine DSM30 User Manual
Page 19
Chapter 1: DSM Installation
19
When used in a multiple display system, connect the DSM to the SeaTalk
hs
Network Switch.
Configuring an E Series System - Multiple Displays
Configuring C Series Displays
The C Series system uses cables with a round 4-pin twist-lock network connector.
A 3m-long C Series cable is included with your sounder module and is also
available in a 10 m length (Raymarine part number E65011). The display cable
attaches to the 4-pin male connector labelled “HSB2”on the connector panel of
the sounder module.
Configuring a C Series System
E Series Display
E Series Display
DSM
SeaTalkhs Network Switch
E55058
SeaTalkhs Cable
SeaTalkhs Cable
SeaTalkhs Cable
D9604-1
C Series Display
Sounder Module
4-pin to 4-pin C Series Cable
D9605-1
See also other documents in the category Raymarine GPS receiver:
- RAYTHEON E32001 (13 pages)
- RAYCHART 420 (101 pages)
- L365 (83 pages)
- SR50 (48 pages)
- A65 (100 pages)
- RS12 (50 pages)
- DSM300 (82 pages)
- NMEA Multiplexer (16 pages)
- Pathfinder (111 pages)
- Pathfinder Radar (244 pages)
- autopilot control unit (111 pages)
- VolvoPenta IPS Autopilot System DPU (16 pages)
- autopilot + ST4000+ (145 pages)
- stand-alone master instrument (45 pages)
- ST80 (15 pages)
- Raystar 125 (8 pages)
- RS12 (38 pages)
- ST6001 (48 pages)
- Pathfinder Radar Scanners (66 pages)
- Chartplotter (101 pages)
- Heading Sensor (24 pages)
- Ray430 (54 pages)
- Viewable Marine Displays (38 pages)
- Marine GPS System (188 pages)
- C Series (244 pages)
- ST8001 (48 pages)
- hsb2 PLUS Series (246 pages)
- 631 PLUS (170 pages)
- navigation system (17 pages)
- ST8002 (48 pages)
- PowerPilot (18 pages)
- ST7002 (52 pages)
- GPS Kit (24 pages)
- 465 (107 pages)
- Ray54E (116 pages)
- GPS Plotter (131 pages)
- GPS navigation (75 pages)
- ST7001 (48 pages)
- 300 (136 pages)
- Raystar 120 (30 pages)
- autopilot (137 pages)
- Platinum Chart Card (29 pages)
- ST6002 (56 pages)
- 320 (139 pages)