beautypg.com

Tighten the screws. do not overtighten – Raymarine DSM30 User Manual

Page 13

background image

Chapter 1: DSM Installation

13

Note:

For fiberglass with a gelcoat surface, you should overdrill the surface to prevent the

gelcoat from chipping when driving in the screw. Before drilling the pilot hole, hand drill
the marked location with an oversized bit and countersink to approximately 3/8" diame-
ter.
4. Drive the supplied #8 screws into the pilot holes. Screw them in about half way.
5. Mount the module to the surface, slipping the screw heads through the four

key holes.

6. Press the module downward so the screws align with the narrow end of the

keyholes.

7. Tighten the screws. Do not overtighten.

1

2

3

6 mm

minimum

D7480-1

D7469-1

See also other documents in the category Raymarine GPS receiver: