Radio Shack ET-687 - Manual (Page 20)

20
• If a call comes in during an intercom
conversation, either of the intercom
parties can answer the call as they
normally would. Simply press the
ringing line’s button. The intercom
call automatically disconnects.
MEMORY DIALING
You can store up to 20 numbers in mem-
ory (ten each in the handset’s and base’s
memory), then dial a stored number by
pressing a one-digit memory location
number.
Use the supplied memory directory
stickers to record your stored numbers.
(Use a pencil in case you need to
change the number later.) Peel the
backing from each sticker and attach
them to the phone as shown.
Notes:
• Each number stored in the hand-
set’s memory can be up to 20 digits,
and each number stored in the base
can be up to 16 digits.
• You cannot dial a number stored in
one memory location (the base or
the handset) using the keypad on
the other.
• An error tone sounds and the phone
exits the storing process if you wait
more than 20 seconds between
each keypress.
Storing a Number in Memory
Follow these steps to store a number in
the handset’s memory. To store a num-
ber in the base’s memory, start at Step 2.
1. Lift the handset.
2. Press MEM . The CHARGE indicator
on the base flashes, or the line indi-
cators on the handset flash.
3. Enter the number and any tone and
pause entries (see “Using Tone Ser-
vices on a Pulse Line” on Page 18
and “Entering a Pause” on Page 21).
Note: Each tone or pause entry
uses one digit of memory.
43-687.fm Page 20 Friday, August 13, 1999 11:12 AM