RCA VCR VR708HF - Manual (Page 12)

10 Chapter 1
Connections & Setup
TV + VCR + Cable Box
Note: Your television and/or cable box back panels may not look exactly like the
models shown here.
1. Connect the VCR to the TV
Connect one end of the supplied RF coaxial cable to the RF OUT jack on the
back of the VCR and the other end to the TV’s antenna input jack.
2. Connect the cable box to the VCR
Connect one end of a second RF coaxial cable (not included) to the cable box’s
TV output jack and the other end to the ANT. IN jack on the VCR.
3. Connect the cable feed to your cable box
Connect the RF coaxial cable feed (not included) to the antenna input jack on the
cable box.
Go To Page 11
Cable Box
VCR's
Signal
Position Remote-Controllable
Cable Box
VCR
Transmitter
Controlling the Cable Box
Your VCR has a built in infra-red
transmitter that can send commands
to certain remote-controllable devices
(like cable boxes). This is helpful for
timer recordings, changing channels,
etc.
Place the satellite receiver on top of
the VCR as shown in the diagram.
CABLE/
ANTENNA
VCR
TV
VIDEO
R L / MONO
S-VIDEO
AUDIO
L
IN
OUT
CH3
CH4
IN FROM ANT
OUT TO TV
From Cable
Line Feed
ANT. IN
RF OUT
CH.
VIDEO
AUDIO
OUT IN
R
L
3 4
CABLE BOX
1
2
3
VCR
TV
Cable Box