RCA VCR VR708HF - Manual (Page 11)

Chapter 1 9
Connections & Setup
TV + VCR + Satellite Receiver
Note: Your television and/or satellite receiver back panels may not look exactly like
the models shown here.
1. Connect the VCR to the TV
Connect one end of the supplied RF coaxial cable to the RF OUT jack on the back of
the VCR and the other end to the TV’s antenna input jack.
2. Connect satellite receiver to the VCR
Connect one end of an RF coaxial cable (not included) to the antenna output jack on
the satellite receiver and the other end to the ANT. IN jack on the VCR.
3. Connect the antenna to your satellite receiver
If necessary, connect an antenna or cable box RF coaxial cable (not included) to the
antenna input jack on the satellite receiver.
4. Connect the satellite feed to the satellite receiver
Connect the satellite receiver’s RF coaxial cable feed (not included) to the satellite
input jack on the satellite receiver.
Go To Page 11
VCR
TV
Satellite
CABLE/
ANTENNA
VCR
TV
VIDEO
R L / MONO
S-VIDEO
AUDIO
L
IN
OUT
CH3
CH4
S-VIDEO
L R VIDEO
OUT
IN FROM ANT
OUT TO TV
SATELLITE
IN
From
Satellite
From Cable
or TV Antenna
ANT. IN
RF OUT
CH.
VIDEO
AUDIO
OUT IN
R
L
3 4
SATELLITE
RECEIVER
1
2
4
3
Satellite
Receiver
VCR's
Signal
Position Remote-Controllable
Satellite Receiver
VCR
Transmitter
Controlling the Satellite Receiver
Your VCR has a built in infra-red
transmitter that can send commands
to certain remote-controllable devices
(like satellite receivers). This is helpful
for timer recordings, changing
channels, etc.
Place the satellite receiver on top of
the VCR as shown in the diagram.