RCA Satellite TV Antenna - Manual (Page 20)

16 Mounting the Mast
2 5/16 x 3" lag screws
4 5/16 x 2" lag screws
4 5/16 " washers
Mounting The Mast On Solid Wood Or
Lap Siding
Materials Needed Tools Needed
• Electric drill with a
3/16" wood bit
• Bubble level
• 1/2" wrench
• 3/8" wrench
• 7/16" wrench
• Pencil
Important Considerations:
• Make sure the wooden surface is structurally sound
• Do NOT mount the dish where someone might use it as a handrail.
• Do NOT mount the dish on any type of aluminum or vinyl siding.
• Do NOT mount the dish on any type of composite paneling, such
as fiber board, particle board, or strand board.
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
Mounting the Mast on Solid Wood or Lap Siding
DANGER
AVOID Power Lines!
When following these
instructions, take
extreme care to avoid
contact with overhead
power lines, electric
lights, and power
circuits. Contact with
power lines, electric
lights, or power
circuits may be fatal. It
is recommended that
the dish be located
more than 20 feet from
overhead power lines.