RCA Satellite TV Antenna - Manual (Page 15)

Preparing for Installation 11
Estimating Cable Requirements
Now that you’ve decided on the exact mounting site, you need to
decide where you want the cable to enter the house, and then figure
out approximately how much cable you are going to need.
The diagram below shows you a “typical” installation scheme,
outlining the cables that are needed. The information on the following
page takes you through the cable estimating process step-by-step.
Cable entry into house
RG-6 coaxial cable #2
(no messenger wire)
DSS receiver
TV
#10 Copper or #8 Aluminum
Grounding wire goes to
Central Building Ground
RG-6 coaxial cable #1
with messenger wire
Grounding block
Messenger (ground) wire
grounded to block
Messenger (ground) wire
attached to the mounting foot
A Few Words About
Grounding the
System
Grounding the satellite
system to the central
building ground helps
protect it and other
components from lightning
damage. Dish installation
should comply with local
codes and the National
Electrical Code (NEC).
Grounding the satellite
system is something you can
probably do yourself. But if
you’re not sure, you should
contact a qualified
electrician.
Estimating Cable Requirements