Radio Shack ET-518 - Manual (Page 7)

7
I
5. nsert the supplied AC adapter’s
barrel plug into the 12V DC jack on
the back of the base. Then route
the adapter’s cord through the
right slot on the base’s bottom and
under the clips as shown. Plug the
adapter into a standard AC outlet.
6. Plug the short modular cord into
the wall plate’s jack.
7. Align the bracket’s keyhole slots
with the wall plate studs and slide
the base downward to secure it.
8. Press and lift out the handset
holder. Rotate the holder 180
°
as
shown, and then snap it back into
place so it holds the handset.
Note: If you later want to mount the
base on a desktop, press
PUSH and
slide the bracket down to remove it
from the base’s bottom.
43-1018.fm Page 7 Tuesday, August 17, 1999 8:53 AM