Radio Shack ET-518 - Manual (Page 15)

15
Note: While you are storing a
number in memory, if you do not
press any button on the keypad
within about 10 seconds, the
handset beeps three times and
you must press
MEMO again to
store the telephone number.
3. Dial the number.
4. Press MEMO again.
5. Press the number ( 1 - 9 ) for the
memory location where you want
to store the number. The phone
beeps twice. The phone number is
now stored in memory.
6. Press TALK twice to exit the store
mode.
7. Repeat Steps 2-6 for other tele-
phone numbers.
8. Remove the plastic covering from
the base’s index sheet with a
small pointed object, such as the
end of a straightened paper clip.
Write the person’s or company’s
name and memory location num-
ber on the sheet in pencil (in case
you want to store a different num-
ber later).
Notes:
• If you receive a call while you are
storing a number in memory,
press
TALK to answer the call.
After the call, begin again at Step
1 to store the number.
• To change the phone numbers
stored in memory, repeat Steps 1-
6. The new phone number
replaces the previously stored
phone number in that memory
location.
• To clear a memory location so no
number is stored there, press
MEMO , PAUSE , MEMO , and then
the location number. The phone
beeps twice and the phone num-
ber is now cleared from the mem-
ory.
• If AC power fails, the phone beeps
three times and keeps stored
numbers in memory.
Entering a Pause in a Memory
Number
In some telephone systems, you must
dial an access code (
9 , for example)
and wait for a second dial tone before
you can dial an outside number. If your
phone is connected to one of these
systems, you might want to enter a
pause at the appropriate point when
you store a phone number in memory.
43-1018.fm Page 15 Tuesday, August 17, 1999 8:53 AM