Radio Shack ET-518 - Manual (Page 6)

6
4. Plug the adapter into a standard
AC outlet.
Caution: You must use a 120V AC/
12V DC adapter that delivers at least
200 milliamps. Its plug must correctly
fit the phone’s
12V DC jack. The sup-
plied adapter meets these require-
ments. Using an adapter that does not
meet these requirements could dam-
age the phone or the adapter.
Mounting the Base on a Wall
Plate
You need a short modular cord (such
as Cat. No. 279-390, not supplied) and
a standard wall plate (Cat. No. 279-
382, not supplied), for this mounting
method.
1. Plug one end of the short modular
cord into the PHONE jack on the
back of the base.
2. Route the short cord downward
through the top left slot on the
base’s bottom and under the clips
as shown.
3. Route the other end of the short
cord through the hole in the
bracket’s center.
4. To attach the supplied bracket to
the bottom of the base, insert the
tabs on the bracket into the slots
on the base, then slide the bracket
up.
43-1018.fm Page 6 Tuesday, August 17, 1999 8:53 AM