Radio Shack ET-518 - Manual (Page 14)

14
1. Be sure TONE/PULSE on the base
is set to PULSE .
2. Dial the service’s main number.
3. When the service answers, press
TONE . Then dial the additional
numbers. The phone sends these
numbers as tone signals.
4. When you complete the call, place
the handset on the cradle or press
TALK to disconnect the call. The
phone automatically resets to the
pulse mode.
Note: We recommend you not use RE-
DIAL to dial numbers that include a
TONE entry.
USING PAGE
PAGE allows someone at the base to
page you at the handset or helps you
find the handset if you misplace it. With
the handset’s
POWER set to ON and its
TALK indicator off, the handset sounds
four sets of four beeps when someone
presses
PAGE on the base.
MEMORY DIALING
You can store nine telephone numbers
in memory and then dial them by
pressing the corresponding memory
location number. Each stored number
can be up to 16 digits long.
Notes:
• When using special tone service
numbers, we recommend that you
manually press
TONE , rather than
storing the entry in memory. How-
ever, you can store the service’s
main number in one location and
numbers for additional information
in other locations. See “Storing/
Chain Dialing Special Service
Numbers.”
• To keep your accounts secure, we
recommend you NOT store your
personal access code for services
such as bank-by-phone in a mem-
ory location.
Storing a Number in Memory
1. Make sure the handset’s POWER
is set to ON and TALK is not lit.
2. Press MEMO .
43-1018.fm Page 14 Tuesday, August 17, 1999 8:53 AM