Zone setup (zonsu), Installer – Russound UNO-S1 CAM6.6T-S1 User Manual

Page 56

INSTALLER

INSTALLATION MENU

2. COMMAND TYPE –

Select the type of source command (e.g., CD, TV, etc.).

(CmdTp)

a. Selected: Learned IR

Choose Learned IR if the pre-programmed IR code library does

(LrnIR)

not support the source component.

i. LEARNED SRC –

Select the learned source bank to be assigned to the source

(LnSrc)

component. Procedure advances to KEY FUNCTION (step 4)

b. Selected: Unassigned

The source select command is cleared. Procedure advances to

(Unasg)

SAVE CHANGES (step 5)

c. Selected: Default

Default selects the same device type and device code previously

(Deflt)

setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 4)

d. Selected: Macro:

(To build macros, see Macro Editor page 61)

(Macro)

i. MACRO -

Macro loads a series of commands which are processed when

(Macro)

activated.

ii. MACRO ID –

Enter the macro ID number. Menu advances to SAVE CHANGES

(MacID)

(step 5)

e. All Other Selections:

Procedure advances to DEVICE CODE (step 3)

3. DEVICE CODE –

Source component code for IR control.

(DevCd)

4. KEY FUNCTION –

Select a function (Play, Enter, etc.).

(KeyFn)

5. SAVE CHANGES? –

Select “yes” to save the changes.

(Save?)

# OF SOURCES (#Srcs)

At this field it is necessary to enter the number of sources used in the CAM6.6 system (1 to 6). This
limits the sources displayed on the keypad in the normal running mode when the source button is
pressed, but also limits source selections in the configuration menus.

See Source Select

Command & # Of Sources - Flow Chart on page 69

ZONE SETUP (ZonSu)

NOTE: This procedure should be performed using the keypad installed in the zone to be configured.
See Zone Setup - Flow Chart on page 70