ResMed VPAP III & III ST - Manual (Page 19)

13 Setting up the VPAP System
English
1. Fill the Passover with water as described in the humidifier manual.
2. Connect the medium (52 cm) air tubing to the right connector port, and the
long air tubing (2 m or 3 m) to the left connector port on the humidifier (H-1).
3. Place the VPAP on top of the Passover (H-2). Do not place the VPAP unit
underneath the humidifier. (This is to avoid water spilling into the unit.)
4. Connect the free end of the medium air tubing to the air outlet of the VPAP
(H-3).
5. Connect the mask system to the free end of the long air tubing. The final
assembly should look like figure H-4.
6. If the VPAP is not already plugged in, see Step 2 on page 11.
!
WARNING
Make sure that the power cord and plug are in good condition and the
equipment is not damaged.
7. Navigate to the humidifier setting (if available) in the VPAP menu and select
"PASSOVER". See “How to Use the Detailed Menu (if enabled by your
clinician)” on page 22.
The VPAP is now ready for use with the ResMed Passover. To start treatment,
see “Starting Treatment” on page 15.
Using the LCD Screen and Keypad
The control panel of the VPAP includes an LCD screen and keypad.
LCD Screen
The LCD screen displays the menus and treatment screens.
To assist you in adjusting the VPAP, the keypad and LCD are equipped with a
backlight. The LCD backlight comes on when the unit is turned on or when you
press a key, and turns off after two minutes.
Start/Stop Mask-fit
LCD screen
Left key
Up/down key
Right key
Front key