Radio Shack PRO-2096 - Manual (Page 65)

65
Beyond the Basics
26 73 152 243 306 411 465 627 754
31 74 155 244 311 412 466 631
32 114 156 245 315 413 503 632
36 115 162 246 325 423 506 654
43 116 165 251 331 431 516 662
47 122 172 252 332 432 523 664
storing talkgroup IDs
Each talkgroup on a trunked radio system is identifi ed by a
talkgroup ID. You can store talkgroup IDs automatically while
scanning the trunked system in Open mode, or manually by
entering the IDs directly.
To automatically store a talkgroup ID, press TRUNK when
the scanner stops on a voice channel transmission or
when a talkgroup ID is indicated in the manual mode. The
ID of the active talkgroup is automatically stored in the
next available ID memory location. Your scanner’s display
indicates where the ID was stored as ID save X-YY, and then
changes to ID#ZZZZZ, where X is the sub-bank number, YY is
the ID number within the sub-bank, and ZZZZZ is the stored
talkgroup ID code. If the ID has already been stored when
you press TRUNK, ID was saved appears on the scanner’s display.
To manually store talkgroup IDs or to edit a stored ID:
1. Navigate to a channel in the desired trunking bank using
MAN, e or d .
2. Press PROG.
3. Press TRUNK.
4. Select the ID memory you wish to edit using MAN, e or d .
5. Enter the talkgroup ID number and press ENT. If necessary,
use the decimal point for a hyphen. If you make a
mistake, Invalid ID. appears and the scanner beeps when
you press ENT. Start over again.