Radio Shack PRO-2096 - Manual (Page 58)

58
Beyond the Basics
4. Press PROG to return to the channel storage bank.
5. Select a channel to begin programming trunking system
frequencies. Use direct channel entry or the e or d keys.
6. Enter the trunking frequency and press ENT. If necessary,
press MODE to change the receiving mode to ED.
7. Repeat Steps 5 and 6 to enter the other EDACS trunking
system channels for the system you wish to monitor.
Motorola VHF and UHF systems
To monitor Motorola VHF and UHF systems, you must
program the scanner with three additional parameters — the
base frequency, step and offset.
1. Press PROG, and then TRUNK to enter the ID program mode.
2. Press FUNC and press (or hold) e or d to select the bank.
3. Press MODE until Motorola appears in the display.
4. Press FUNC, then 2. The following appears:
Base freq:
406.0000
Offset: 380
Step:25.0KHz
5. While B in Base blinks, if necessary, enter the desired
base frequency and press ENT.
6. While O in Offset blinks, if necessary, enter the offset
number and press ENT.
7. While S in Step blinks, repeatedly press e or d to select
the step number, 5, 6.25, 7.5, 12.5, 15, 25.0, or 50.0kHz,
and then press ENT.
Base frequency, step and offset vary for each individual
UHF trunking system. You can get information about
these frequencies for the trunking system you want to
scan using the Internet or locally published guidebooks.
• Systems with multiple channel ranges can be programmed
Notes Notes