Radio Shack ET-928 - Manual (Page 7)

7
3. Plug one end of the supplied long
modular cord into the phone line
jack on the back of the base.
4. Plug the AC adapter into a standard
AC outlet.
5. Plug the modular cord’s other end
into a modular phone line jack.
6. For the best reception, adjust the
base’s antenna so it stands straight
up.
Mounting on a Wall Plate
1. Push in the two tabs on the top of
the mounting bracket, then lift off the
entire bracket.
2. Plug one end of the supplied short
modular cord into the phone line
jack on the back of the base, then
press the cord into the center
groove on the bottom of the base.
3. Insert the supplied AC adapter’s
barrel plug into the DC 9V jack on
the back of the base. Then route the
cord through the strain relief slot
and press the cord all the way down
into the groove on the bottom of the
base.
illus -- enlarge to
fill space
illus -- label strain relief
43-1098.fm Page 7 Tuesday, August 17, 1999 4:03 PM