Radio Shack ET-928 - Manual (Page 15)

15
Switching Between the
Handset and Speakerphone
To switch from the handset to the
speakerphone at any time during a call,
press
HOLD on the handset, then
SPEAKER on the base so its red indica-
tor turns on, and begin the conversation.
To switch from the speakerphone to the
handset, lift the handset off the base. If
the handset is already off the base,
press
HOLD on the base. The red
SPEAKER indicator flashes. Then press
HOLD on the handset to release the
hold.
ADJUSTING THE VOLUME
The handset’s VOLUME control lets you
set the volume you hear through the
handset to one of four levels. The base’s
VOLUME control lets you set the volume
of the speakerphone to one of eight lev-
els.
To turn the volume up or down during a
call, repeatedly press
VOLUME s or t on
the handset or base. The ET-928 beeps
once each time you press
VOLUME s or
t. When you reach the highest or lowest
volume level, the ET-928 beeps three
times.
USING REDIAL
To redial the last number dialed, press
REDIAL on the handset or base when
you hear the dial tone.
illus of handset HOLD location
illus of base VOLUME
illus of base VOLUME
illus of handset/base
REDIAL locations
43-1098.fm Page 15 Tuesday, August 17, 1999 4:03 PM