Using tone services on a pulse line, Changing channels – Radio Shack ET-928 User Manual

Page 17

Note: If you do not have any special
phone services, pressing

FLASH

might

disconnect the current call.

USING TONE SERVICES
ON A PULSE LINE

Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these services.

With

T/P

set to

, just press

when

you want to begin sending tones. Any
additional numbers you dial are sent as
tone signals. When you hang up, the
phone automatically resets to the pulse
mode.

CHANGING CHANNELS

The ET-928 continuously scans chan-
nels (frequency pairs used between the
base and the handset) and automatical-
ly selects a clear one each time you
make or receive a call using the hand-
set.

If you notice interference during a call,
however, you can repeatedly press

IN-

TCM

on the handset to try to find a clear-

er channel. The ET-928 changes to a
different channel each time you press

INTCM

Note: You cannot change the channel
while using

HOLD

43-1098.fm Page 17 Tuesday, August 17, 1999 4:03 PM