Renesas SuperH Family E10A-USB - Manual (Page 44)

36
2.2.5 Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_
SET Command
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Event
Condition 3 are disabled.
2. When an Event Condition is satisfied, emulation may stop after two or more instructions have
been executed.
3. If a PC break address condition is set to the slot instruction after a delayed branch instruction,
user program execution cannot be terminated before the slot instruction execution; execution
stops before the branch destination instruction.
2.2.6 Note on Setting the UBC_MODE Command
In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set,
Ch10 (IA_OA_R) and Ch11 (OA_OA_CT_R) of Event Condition cannot be used.
2.2.7 Note on Setting the PPC_MODE Command
In the [Configuration] dialog box, if [User] is set while the [PPC mode] list box has been set, Ch1
and Ch2 of the performance analysis function and options 1 and 2 of the profile function cannot be
used.