RCA RCU450 - Manual (Page 5)

5
1 2 3
4 5 6
7 8 9
0
ON•OFF
TV CODE
Program for TV—
Direct Entry Method
1. Manually turn on the TV.
2. Locate the enclosed TV Code List.
Find your brand of TV.
Note: If your brand isn’t listed,
use one of the Code Search methods
to program this remote control
(See Code Search on page 9).
3. Press and hold the CODE SEARCH
key for approximately three seconds
until all four component keys
light up. Then release the
CODE SEARCH key.
4. Press and release the TV key.
The TV key remains lit.
5. Use the number keys to enter
the first code listed for your brand.
After you enter a valid 3-digit code,
the component key light turns off.
Note: If you enter an invalid code,
the lighted component key will flash
rapidly. Start over at step 3.
6. Aim the remote at your TV and press
the ON•OFF key. If your TV turns
off, you have found the correct code.
7. Enter the code in the box provided
on this page for future reference.
8. If your TV doesn’t turn off, repeat
steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program this
remote (See Code Search on page 9).
For a description of each key on
the remote control, refer to the Key
Descriptions section on page 3-4.
In order for the four component universal remote to control
your TV, you must program it with the TV code that matches
your TV. These instructions explain the preferred method
of programming the remote—the Direct Entry method.
CODE
SEARCH
RCU450_US_IB_REVA 10/22/03 9:02 Page 5