Battery installation and information, 4 component universal remote key descriptions – RCA RCU450 User Manual
Page 3
3
Battery Installation
and Information
Your universal remote requires two AAA Alkaline batteries
(batteries may or may not be included, depending on model).
To install the batteries:
1. Remove the battery compartment cover.
2. Insert the batteries, matching the
batteries to the (+) and (–) marks
inside the battery compartment.
3. Press and push the battery cover
back into place.
Note:
Reprogramming may be
required after batteries are replaced.
Congratulations on your purchase of the 4 component
universal remote by RCA. This universal remote controls
up to four electronic components and makes juggling remote
controls a thing of the past. You can program this RCA
universal remote to operate most models of most brands of
infrared, remote-controlled components manufactured after
1990. (See the enclosed Code List for a complete list of brands.)
The 4 component universal remote is easy to use, easy to
program and gives you control at the touch of your fingertips.
Note:
The 4 component universal remote is already
programmed to operate most RCA, GE and PROSCAN
branded TVs, VCRs, DVD players and satellite receivers (DBS).
Just press the corresponding component key—
VCR
for a VCR;
DVD•AUX
for a DVD player;
TV
for a television;
DBS•CABLE
for a satellite receiver or a cable box.
4 Component
Universal Remote
Key Descriptions
Component keys (
DVD•AUX
,
DBS•CABLE
,
VCR
,
TV
): select the component you
want the remote to operate. (Lighted
component key indicates operating mode).
For example, after you’ve programmed
the remote to operate your TV, you must
press the
TV
key first to put the remote in
TV Mode. While in TV Mode, the
CHAN
keys change the channel on the TV, the
VOL
keys adjust the TV’s volume, etc.
Transport keys–
REW
(Rewind),
PLAY
,
FF
(Fast Forward),
PAUSE
,
STOP
: operate
the same as your original VCR or DVD
remote control, although key labels may
vary (
REVERSE
,
FORWARD
).
Backlight Key (select models only)–turns
backlighting on/off. Backlighting will remain
on for approximately 6 seconds after last
keypress to conserve battery life.
RCU450_US_IB_REVA 10/22/03 9:02 Page 3