beautypg.com

Installation, Locating your gas fireplace, Installation checklist – Regency B36X User Manual

Page 8

background image

8

Regency Bellavista™ B36X Gas Fireplace

INSTALLATION

This includes:

1) Clocking the appliance to ensure the correct

fi ring rate (rate noted on label) after burning
appliance for 15 minutes.

2) If required, adjusting the primary air to ensure

that the fl ame does not carbon. First allow
the unit to burn for 15-20 min. to stabilize.

CAUTION: Any alteration to the product that
causes sooting or carboning that results
in damage is not the responsibility of the
manufacturer.

LOCATING YOUR

GAS FIREPLACE

A) Flat on Wall
B) Flat on Wall Corner
C) Recessed into Wall/Alcove
D) Corner

Diagram 1

1) When selecting a location for your fi replace,

ensure that the clearances are met.

2) The appliance must be installed on a fl at,

solid, continuous surface For example a
wood, metal or concrete fl oor or in a raised (on
the wall) application. The appliance must be
installed on a metal or wood panel extending
the full width and depth of the appliance.

3) The B36X Bellavista™ Gas Fireplace can

be installed in a recessed position or framed
out into the room as in A, B, C and D. See
Diagram 1.

INSTALLATION

CHECKLIST

1) Locate appliance

a) Room location (Refer to "Locating Your

Gas fi replace" section)

b) Clearances to Combustibles (Refer to

"Clearances" section)

c) Mantel Clearances (Refer to "Combustible

Mantel Clearances" section)

d) Framing & Finishing Requirements (Refer

to "Framing & Finishing" section)

e) Venting Requirements (Refer to "Venting"

section)

2) Assemble Top Standoffs and Top Facing

Support and Side Nailing Strips (Refer to
"Unit Assembly Prior to Installation" Section).
NOTE: Must be done before installing unit
into place.

3) Install vent (Refer to "Venting" sections).

4) Make gas and electrical connections. Test

the pilot. Must be as per diagram (Refer to
"Pilot Adjustment " section).

Convert to propane if desired (Refer to "Gas
Line Installation" and "Conversion Kit from
NG to LPG" sections).

5) Install standard and optional features. Refer

to the following sections:


a. LP Conversion Kit (Optional)

b. Brick Panels (Optional)

c. Log Set Installation

d. Standard Flush Door

e. Full Screen Door (Optional)

f. Flush Panel/Louver (Optional)

g. Remote control,Wall Switch or
Thermostat (Optional)

h. Fan Installation (Optional)

6) Final check.

4) This appliance is Listed for bedroom

installations using the standard Remote
(millivolt thermostat system). Some areas
may have further requirements, check local
codes before installation.

5) The B36X Gas Fireplace are approved for

alcove installations, see "Clearances" section
for details.

6) We recommend that you plan your installation

on paper using exact measurements for
clearances and floor protection before
actually installing this appliance. Have an
authorized inspector, dealer, or installer
review your plans before installation.

Note: For vent terminations refer to

"Exterior Vent Termination Locations"
section.

HEATWAVE

DUCT SYSTEM

(OPTIONAL)

#946-556

The HeatWave Air Duct Kit increases the
effectiveness of your fi replace by dispersing
warm air from the fi replace to remote locations in
the same room or other rooms in your home.

Up to two kits may be installed on the fi replace.
Please Note: Only 1 HeatWave kit may be
operated at one time. This includes the internal
blower option as well.