Radio Shack 43-3856 - Manual (Page 7)

Installation
7
4. Route the adapter’s cord through the hook on
the back.
5. Plug the adapter into a standard AC outlet.
C
ONNECTING
, C
HARGING AND
R
EPLACING THE
B
ATTERY
P
ACK
The phone comes with a rechargeable Ni-Cd
(nickel-cadmium) battery pack installed in the
handset, but not connected. Before using your
phone, you must connect the battery pack. Then
charge it for about 24 hours.
!
1. Press down and slide off the battery pack
compartment cover.
2. Lift the battery pack out of the compartment.
3. Plug the battery
pack’s connector into
the socket in the
compartment. The
connector fits only
one way.
4. Put the battery pack
in the compartment.
5. Replace the cover.
!
IMPORTANT
!
The EPA
certified RBRC
®
Battery
Recycling Seal
on the nickel-
cadmium (Ni-Cd) battery
indicates RadioShack is
voluntarily participating in an
industry program to collect
and recycle these batteries at
the end of their useful life,
when taken out of service in
the United States or Canada.
The RBRC program provides
a convenient alternative to
placing used Ni-Cd batteries
into the trash or the municipal
waste stream, which may be
illegal in your area. Please call
1-800-THE-SHACK (1-800-
843-7422) for information on
Ni-Cd battery recycling and
disposal bans/restrictions in
your area. RadioShack’s
involvement in this program is
part of the company’s
commitment to preserving our
environment and conserving
our natural resources.
Battery Pack
Connector
43-3856.FM Page 7 Saturday, February 28, 2004 6:45 PM