Roland Bass Amplifier CB-60XL - Manual (Page 8)

6
EQUALIZER
CUBE-60XL BASS
11. [BASS] Knob
Adjusts the tone quality of the lower range.
12. [MIDDLE] Knob
Adjusts the tone quality of the midrange.
15. [TREBLE] Knob
Adjusts the tone quality of the upper range.
CUBE-120XL BASS
11. [BASS] Knob
Adjusts the tone quality of the lower range.
13. [LOW-MID] Knob
Adjusts the tone quality of the lower midrange.
14. [HIGH-MID] Knob
Adjusts the tone quality of the upper midrange.
15. [TREBLE] Knob
Adjusts the tone quality of the upper range.
EFX
16. [EFX] Knob
Turn this knob to CHORUS or POLY OCTAVE
to select the corresponding eff ect. Turn the
knob to adjust the amount of eff ect applied.
The ON indicator lights up when EFX is turned on,
and goes out when EFX is turned off . You can also
turn EFX on and off using optional foot switches.
* Graduations for CHORUS and POLY OCTAVE on
a panel are for reference. Be sure to check the
sound as you adjust the eff ects.
Knob Position Description
CHORUS
In this eff ect, a slightly detuned sound is
added to the original sound, giving the
sound greater breadth and fullness.
Turning the knob to the right increases the
rate and deepens the chorus eff ect.
POLY OCTAVE
This adds sound lowered by an octave
to the original sound. Since you can play
chords even when using this eff ect, you can
use it to fatten the sound of your chordal
playing as well.
Turning the knob to the right increases the
eff ect sound.
DELAY/LOOPER
17. [DELAY/LOOPER] Knob
You can switch to DELAY or the LOOPER
function by positioning this knob.
When the knob is at DELAY, this functions as
a delay.
When the knob is positioned at LOOPER, this
functions as a looper.
* The scale indications for DELAY and LOOPER are just a general
guide. Be sure to check the actual sound as you adjust the eff ect.
The indicator lights up when DELAY or LOOPER is on and goes out
when it’s off .
To use DELAY
17. [DELAY/LOOPER] Knob
Set the knob in the position to turn DELAY on. The position of the
knob within this range adjusts the volume of the delay sound.
You can also switch DELAY on and off using an optional footswitch
pedal.
18. [REC/PLAY/DUB] Switch
This will blink in synchronization with the delay time.
19. [TAP/STOP] Switch
Use this to set the delay time. When you press the switch twice, the
delay time will be set to the time interval at which you pressed the
switch. The maximum length is 2000 ms.
Setting the Delay Time for Short Delay
If you hold down the switch for one second or longer, the delay time
will be set to 30 ms. Each time you then press the [REC/PLAY/DUB]
switch, the delay time will change over four steps (30 ms/50 ms/
70 ms/90 ms) to a maximum of 90 ms.
* The short delay cannot be set using the foot switch.