Roland Bass Amplifier CB-60XL - Manual (Page 13)

11
Por
tuguês
Italiano
Deutsch
N
eder
lands
Español
Fr
anç
ais
English
Using a Latch-type Foot Switch
The CUBE-60XL BASS/CUBE-120XL BASS also support latch-type foot
switches. If you’re using a latch-type foot switch, make the following
settings.
FOOT SW TYPE setting
There are two types of foot switches.
Type Operation
Momentary type
(BOSS FS-5U, etc)
This type remains on (or off ) while depressed
and switches off (or on) when released.
Latch type
(BOSS FS-5L, etc.)
This type switches on or off each time it is
depressed.
* The BOSS FS-6 can operate as either a momentary or latch-type
pedal switch.
CUBE-60XL BASS
At the factory settings, the momentary type is selected. You can
change this setting as follows.
• To specify the latch type
Turn on the power while holding down the [TAP/STOP] switch.
• To specify the momentary type
Turn on the power while holding down the [REC/PLAY/DUB] switch.
* The setting you specify is remembered even while the power is
turned off .
CUBE-120XL BASS
Set the [FOOT SW TYPE] switch on the rear panel
to FS-5L (LATCH).
Foot Switch Settings
Polarity switch
(RING) (TIP)
BOSS FS-5L
REVERB
COMP/DRIVE
EFX
SOLO
REVERB
COMP/DRIVE
EFX
SOLO
B A
Set the switches as shown as bellow.
BOSS FS-6
(RING) (TIP)
Polarity switch
BOSS FS-5L+FS-5U
DELAY/
REC/PLAY/DUB
TAP/STOP
DELAY/
REC/PLAY/DUB
TAP/STOP
B A
Set the switches as shown as bellow.
BOSS FS-6
* Even if FOOT SW TYPE is set to FS-5L (LATCH), you must always use
a momentary-type foot switch for TAP/STOP. This function will not
work correctly with a latch-type foot switch.
Important Notes When Using a Latch-type Footswitch Pedal
The on/off state of the footswitch pedal takes precedence over the
control panel for switching COMP/DRIVE, EFX, DELAY, or REVERB on
and off .
However, the on or off states of COMP/DRIVE, EFX, DELAY, or REVERB
stored in memory using the SOLO function take precedence when
saved SOLO-function panel settings are called up. Such cases may
result in confl icting indicator displays on the control panel and the
footswitch pedal, but this is not a malfunction.
Convenient Applications
You can use either of the following settings to control operation when
the panel settings for COMP/DRIVE, EFX, DELAY, and REVERB are called
up using the SOLO function.
Foot switch priority mode
Make the on/off state of the footswitch pedal always take priority.
To make the setting:
Hold down the [SHAPE] switch and switch on the power.
Memory priority mode (factory setting)
Make the on/off state saved using the SOLO function take priority.
To make the setting:
Hold down the [TUNER] switch and switch on the power.
* The changed setting remains in memory after the power is switched
off .