RoyalTek RN5 - Manual (Page 13)

2.1.3 How to Use Car holder
Figure 2: Car holder side views
Table 2-2: Car holder
No Function
1
USB
Port/Docking
connector
The mini-USB connector of car cradle can be used to charge power
only.
2.2. How to Use mounting bracket.
The NS-4102T comes with a car mount kit and a car charger to help install your device in your
vehicle. The car mount kit uses a suction cup on the windshield to offer flexible mounting options
for the NS-4102T.
Warning: Some countries prohibit the mounting of any electronic device on the vehicle
dashboard. Be sure to check your local laws for acceptable mounting areas before installing
the car mount bracket.
This section shows how to install the car mount kit in your vehicle’s windshield using the suction
cup. The NS-4102T uses a snap on mounting cradle to use when the device attaches to the car
mount. Below is the backside view of the NS-4102T in the cradle.
1. Clean the mounting surface with a glass cleaner and a clean cotton cloth.
2. If the ambient temperature is below +15°C (60°F), you can warm the mounting area
and the suction cup (e.g. with a hair dryer) to ensure a strong suction bond.
3. Install the car mount on the selected area.
a. Press the suction cup of the car mount firmly against to the windshield. (See Figure
2-3-1)
b. Press down the lever to fix the suction cup in place.
c. Adjust the angles of the arm to your proper viewing position.
13