RCA SpeedTouch 716v5 (WL) - Manual (Page 64)

Chapter 4
Voice over IP
E-DOC-CTC-20050401-0008 v1.0
56
Command overview In the table below all standard service codes of the telephony services are listed. On
your SpeedTouch™ these might be different, depending on your provider.
Conference Call (3 Party) To set up a conference call:
1 Call person A.
2 Dial R , 2 . Person A is put on hold.
3 Wait for the dial tone.
4 Dial the number of person B.
5 Person B picks up the phone.
6 Dial
R
,
3
.
Once the conference call has been established, you
can:
1 Dial R , 2 to put the 2 calls on hold.
2 Dial R , 3 to retrieve the 2 held calls.
CLIR on call basis It is possible to hide your phone number for one
particular call. Dial
*31*
directly followed by the
phone number of person A.
Forced FXO To make a phone call over the regular telephone
line:
1 Dial *01* .
2 Wait for the dial tone, and then dial the phone
number of person A.
To use the service: Proceed as follows:
Phone command: Is used to:
R 0 drop a held call
reject an incoming call
R 1 terminate an active call and switch to the
waiting or held call
R 2 put a call on hold
switch between active and waiting or held call
put a conference call on hold
R 3 establish a 3-way conference call
R 4 transfer a call
*31* make an anonymous call (use CLIR) on call
basis
*01* use the regular telephone line