RCA SpeedTouch 716v5 (WL) - Manual (Page 62)

Chapter 4
Voice over IP
E-DOC-CTC-20050401-0008 v1.0
54
Activating/Deactivating
the services
Before to be able to use one of the provisioned telephony services, the service has to
be activated. This might have been done during the initial setup of your
SpeedTouch™.
Otherwise, you can activate or deactivate a particular telephony service:
on the SpeedTouch™ web pages: see “ (De)activating services on the web
pages” .
or simply by dialling the regarding activation code on your telephone: see
“ (De)activating services on your telephone” .
(De)activating services
on the web pages
To activate a service on the web pages:
1 Go to the SpeedTouch™ web pages.
2 In the menu select Toolbox > Telephony.
3 On the top right, click Configure.
4 Under Pick a task... list click Configure telephony services.
5 A list of telephony services provisioned by your provider is shown:
6 Select those services you want to activate.
7 Click Apply.
(De)activating services
on your telephone
To activate a service using the attached telephone:
1 Hook off the phone.
2 Dial an ‘*’ followed by the activation code. You can dial a ‘#’ after the
activation code to indicate the end of the code, as a result of which the service
will be activated instantly.
3 Wait for the confirmation tone, and then hook on the phone.
To deactivate the service, clear the corresponding check box.
The activation code depends on your provider’s configuration. The
activation codes can be found on the Telephony Services web page.
To deactivate the service, dial a ‘#’ followed by the activation code.
The Forced FXO service cannot be activated on your phone.