beautypg.com

Using the solo function, Saving the panel settings, Calling up panel settings – Roland CUBE-80X User Manual

Page 18: Changing or checking saved panel settings, P. 16), Returning to the factory-default settings

background image

16

Using the SOLO Function

You can save and call up the panel settings (those enclosed by

the line in the figure) for sounds you create with the LEAD

channel. On this unit, this function is called “SOLO.”

By default, “Loud Metal” (p. 20) sample settings are saved in the

SOLO function.

*

The VOLUME setting for the LEAD channel is not saved.

*

The LOOPER settings and the recorded phrase are not saved.

1.

Create a sound with the LEAD channel.

2.

Set the SOLO volume at 0 (zero).

If the SOLO volume is set

high, the sound may be

unexpectedly loud when the

panel settings are saved.

Before saving, lower the

volume to 0.

3.

Press and hold the SOLO switch on the panel
until the indicator starts to flash
(approximately 2 seconds or longer).

When the panel settings are

saved, the indicator

changes to a steadily

lighted state.

*

Never switch off the power

while the indicator is flashing.

4.

Adjust the volume for the SOLO function.

*

Saved panel settings remain in memory even after the power is

turned off.

1.

While at the JC CLEAN or LEAD channel, press
the SOLO switch on the panel.

The SOLO indicator lights up and the panel settings stored

in memory are called up.

*

When no panel settings have been saved, or when you’re using the unit

for the first time, the product’s factory-default settings (“Loud Metal” (p.

20) sample settings) are called up.

1.

Press the SOLO switch on the panel to call up
the saved settings.

2.

Turn the panel knob for the item you want to
change, and modify the setting.

*

The SOLO indicator goes out briefly when the position of the

turned knob coincides with the position stored in memory.

3.

Pressing the SOLO switch on the panel until
the indicator starts to flash (approximately 2
seconds or longer) saves the changes to the
settings.

*

Never switch off the power while the indicator is flashing.

*

Once the new settings have been saved, the previous settings in

effect before the changes cannot be called up again.

*

To quit without saving the changes, press the SOLO switch or the

SELECT switch.

You can switch channels using the SELECT switch and the SOLO

switch.

*

When a momentary-type footswitch pedal is connected, it also

performs the same operation.

Saving the Panel Settings

Calling Up Panel Settings

Changing or Checking Saved Panel
Settings

Switching the SOLO Function and the
LEAD and JC CLEAN Channels

SELECT

switch

SOLO

switch

SOLO switch

SELECT switch

Returning to the Factory-default Settings

Hold down the TAP switch and the SOLO switch at the same

time and switch on the power.

The SOLO indicator flashes and the settings saved with the

SOLO function are returned to their factory defaults.

cube-80x.book 16 ページ 2008年12月12日 金曜日 午後6時7分