Roland CUBE-80X - Manual (Page 12)

10
Panel Descriptions
s
Turns the power on and off.
941
* Once the connections have been completed (p. 11), turn on power to
your various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
1. Make sure that all volume controls on this
unit and connected devices are set to 0.
2. Turn on all the devices connected to this
unit’s INPUT jack and AUX IN jack.
3. Turn on this unit.
943
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down, you
may still hear some sound when the power is switched on, but this
is normal, and does not indicate a malfunction.
942
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will operate
normally.
4. Adjust the volume levels for the devices.
5. Before switching off the power, lower the
volume on each of the devices in your
system, and then turn off the devices in the
reverse of the order followed when switching
them on.
945
* If you need to turn off the power completely, first turn off the POWER
switch, then unplug the power cord from the power outlet. Refer to
“Power Supply” (p. 4).
POWER Switch
cube-80x.book 10 ページ ２００８年１２月１２日 金曜日 午後６時７分