Roland Function Mode Quick Reference VR-700 - Manual

VR-700 Function Mode Quick Reference
This publication shows you how to make changes in the parameters related to organ and ensemble sounds. These parameters make up only a portion
of all the parameters that can be set in the Function mode. For detailed explanations concerning these parameters, and for information on all the other
parameters, which are not covered in this publication, refer to the VR-700 Owner’s Manual.
Operations in Function Mode
1. Press the [FUNCTION/ENTER] button to enter Function
mode.
2. Use the [+] button or [–] button to select the Group.
Refer to the relevant pages in this document to learn about the
correspondence between Groups and what is indicated in this unit’s
display.
3. Press the sound button that corresponds to the
parameter for which you want to change the settings.
Refer to the relevant pages in this document to learn about the
correspondence between the buttons and the parameters.
4. Use the [+] button or [–] button to change the value of
the setting.
5. To exit Function mode, press the [DISPLAY/EXIT] button
twice.
Saving Your Settings As a Favorite
1. Press the [DISPLAY/EXIT] button twice to exit Function
mode.
2. While together holding down both the [WRITE] and
[BANK] buttons, press one of the FAVORITE [1]–[8]
buttons to specify the save-destination bank.
3. While holding down the [WRITE] button, press one of the
FAVORITE [1]–[8] buttons to specify the save-destination
favorite number.
With the Group already selected, press the [+] button or [–] button until is shown in the display.
Organ Sound Parameters
Parameter Wheel Type Amp Type Organ Fine Tune Leakage Level Key On Click Level
Value
1: VINTAGE 1
2: VINTAGE 2
3: SOLID
4: CLEAN
1: Jazz oriented
2: Vacuum tube amp for guitar
3: Rock oriented
4: Readily distorts
5: Level easily set
-50– +50 (cent) 0–127 0–31
Remarks
VINTAGE 1/2 are tonewheels
representative of the 70s/60s.
SOLID emphasizes the lower-
range harmonics of VINTAGE 1.
CLEAN is free of leakage noise.
1, 3, 4, and 5 are amps with
rotating speakers. 2 is a guitar
amp.
– – –
Tone button
(blink red)
Parameter Key Off Click Level Reverb Send Level Active Amp Enhancer – –
Value 0–31 0–127 OFF, ON – –
Remarks – –
Enhances the distortion
characteristics according to
the Amp Type
– –
Copyright © 2010 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
* 5 1 0 0 0 1 2 3 1 4 - 0 2 *
VR-700_l_QuickEditGuide_e.fm 3 ページ ２００９年１１月２５日 水曜日 午前９時３７分