Runco DTV-992 - Manual (Page 64)

APX-13
Appendix 2
ALIGN FROM MIDPOSITION ON ALL SOURCES
When ALIGN FROM MIDPOSITION is selected, the auto-
matic convergence on all sources will be carried out auto-
matically, but starting from the midposition settings.
By projecting alternately red and blue lines, 25 convergence
areas are aligned to the green pattern. The process will
repeat for as many times as the total number of the sources
until all sources are perfectly aligned.
Follow the steps below to select:
Highlight ALIGN FROM MIDPOSITION below ON ALL
SOURCES by pushing up or down keys of the control
disc;
Press the button to start up the automatic
convergence of the entire screen.
If the process is successfully completed, the projector will
return to image display of the current source.
Use this option when the convergence if far from proper
alignment.
INTERRUPTING THE AUTOMATIC CONVERGENCE
PROCESS
The process of the above-mentioned automatic convergence
can be interrupted at any moment by pressing the
button.
After the button is pressed, the projector will leave
the automatic convergence process and a message will be
displayed informing of the action:
Status: Forced
ERROR MESSAGES
The status line in the AUTOCONVERGENCE menu gives
three possible messages:
Ready: before automatic convergence starts;
Forced: when interrupting the process;
Forced break: error message.
Error messages are displayed when the automatic conver-
gence is not successfully completed.
EYE-Q
TOUCH UP
AUTOCONVERGENCE
QUICK AUTOPICTURE
FULL AUTOPICTURE
EYE-Q SETUP
EYE-Q DIAGNOSTICS
Select with
then .
to return or
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
ready
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
forced exit
AUTOCONVERGENCE
ON CURRENT SOURCE:
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES: (XX)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Select with
then .
to return or
STATUS:
ready/forced exit/forced break