NAD L 76 - Manual (Page 8)

ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
8
CONNECTING AUDIO EQUIPMENT
CAUTION
• Do not plug the power cord of any component into AC outlets and do not turn their POWER switches
on until all connections have been performed.
• The cable connectors should be fully inserted into the jacks. Loose connections may cause hum and
noise.
• Read the instructions for each component you intend to use with the receiver.
AUDIO SIGNAL JACKS
AUX IN jacks Connect the Auxiliary output jacks to the AUX IN jacks.
TAPE (IN/OUT) jacks
• Connect the TAPE jacks to the cassette deck.
• Connect the cassette deck output (LINE OUT)jacks to the IN jacks.
• Connect the cassette deck output (LINE IN)jacks to the OUT jacks.
AUDIO CONNECTION CORDS
To make these connections, use interconnect cords with RCA plugs. Make sure that you connect the white
pin-plug to the white jacks (left) and the red pin-plug to the red jacks (right).
CONNECTING THE PRE OUT JACKS
Since subwoofer signals are not amplified, use a subwoofer with a built-in amplifier or connect it to the
amplifier connected to this unit.
NOTE
• If a speaker is connected directly to the PRE OUT jack without an amplifier connected, no sound comes
from the speaker.
CONNECTING THE AC POWER
Be sure to connect the power cord to an AC outlet which supplies the correct voltage.
• Hold the power plug when plugging or unplugging the power cord.
White
L L
R R
White
Red Red