NAD L 76 - Manual (Page 25)

25
REMOTE CONTROL UNIT
PUNCH-THROUGH
The HTR L76's "punch-through" function allows you to retain a function key from one Device Select
"page" on another, so that, for example, the AMP "SURR MODE" function might still control the L76
when the DVD Device Selector page is active
NOTE
The HTR L76's "VOL" and "MUTE" keys are preprogrammed as "punched-through" for all Device
Select pages: "VOL" will operate the L76's master-volume regardless of the currently selected device.
The "SURR." "CENTER," and "SUB" Channel Volume controls similarly are pre-programmed as
punched-through. To set a punch through, after entering the Learning Mode, and pressing the desired
key to be punched-through, simply press the device key twice of the device to punch through to. The
status LED will turn green; press the Device Selector key again to exit Learning Mode.
Example: Punch-through the from the DVD "page" to the AMP "SURR MODE" key:
• On the HTR L76, simultaneously press-and-hold "DVD" and (OPEN/CLOSE); the Learn LED
turns steady green.
• Press "SURR MODE"; the Learn LED turns amber.
• Press "AMP" twice; the Learn LED turns green.
• Press "DVD" again to exit the learning mode.
COPY A COMMAND FROM ANOTHER KEY
You may copy a command from any HTR L76 key to any other. To copy a key function, after entering the
Learning Mode, and pressing the desired key to be copied to, simply press the device key from which you
wish to copy, having first pressed its Device Selector key if it resides on another "page." The status LED
will turn green; press the Device Selector key again to exit Learning Mode.
Example: Copy the Pause command from the DVD page to the AMP key:
• On the HTR L76, simultaneously press-and-hold "AMP" and (OPEN/CLOSE); the Learn LED
turns steady green.
• Press (pause); the Learn LED turns amber.
• Press "CD"; press (pause); the Learn LED turns green.
• Press "AMP" again to exit the learning mode.
NOTE
The copy and punch-through functions are similar. However, if you copy a command and then
subsequently delete, or over-write the original (source-key) command, the copied-to key's command
remains unchanged. If you punch-through to a command and then delete or over-write the original
key, the punched-through functions also change accordingly.
MACRO COMMANDS
A "macro" command is a series of two or more remote codes issued automatically from a single key press.
You might use a macro to automate a simple command sequence, such as, "Turn on the DVD player and
then press 'play." Alternatively, you might compose an elaborate macro to power up an entire system,
select a source, choose a SURROUND MODE, and begin playback-again, all from a single key press. The
HTR L76 can store one macro on each of its function keys (these exclude the Device Selector keys).
NOTE
Macros are independent of the currently selected device.
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA