NAD L 76 - Manual (Page 24)

24
REMOTE CONTROL UNIT
CONTROLLING THE L76
The HTR L76 is divided into two main sections. Eight Device Selector keys at the top-"AMP", "DVD,"
"TV," and so on-set the handset's remaining keys to a "page" of commands to control a particular
component. A Device Select key determines only what component the HTR L76 will command; it does
not perform any function on the receiver. All of the remaining keys are function keys that can "learn"
control codes from virtually any infrared remote controller, allowing you to teach the codes of your
equipment, regardless of brand, to the HTR L76.
However, the HTR L76 is already preprogrammed to operate the L76. All of the function keys on the
"AMP," "TUNER," and "DVD" Device Selector "page" perform L76 functions. (The HTR L76 can also
command many other NAD components, from its "CD" and "TAPE" pages.)
It is important to note that certain HTR L76 keys perform different functions depending on the selected
Device Selector "page." The colour of the Device Selector key-labelling corresponds to the labelling of the
function keys. Most centrally, the orange "AMP" Device Selector "page" corresponds to the orange
input-select labelling adjacent to the numeric keys: When the HTR L76's "AMP" Device Selector page is
active; these keys select the receiver inputs. Similarly, the red "DVD" Device Selector "page" corresponds
to several red labels, the green "TV" page to green labels, and so on.
LEARNING CODES FROM OTHER REMOTES
Begin by positioning the HTR L76 "nose-to-nose" with the source remote so the two devices' infrared
windows are about 2 inches apart.
• Enter Learning Mode: On the HTR L76, simultaneously press-and-hold for 3 seconds both a Device
Selector key and the "OPEN/CLOSE" key (just below the "DISP" key), until the Learn LED at
the centre of the HTR L76 turns steady green.
• Press the HTR L76's function key you wish to teach a command; the Learn LED will turn amber.
• Press-and-hold the function key on the source remote: The HTR L76's Learn LED will flicker amber
for a second or two, then turn solid green. The command is learned.
• Press the HTR L76's Device Selector key again to exit the learning mode. If the Learn LED does not
flicker amber you may need to vary the distance between the remotes. If the Learn LED turns red
rather than green, that particular command of that source remote command could not be learned.
CANCEL OPERATION
You can cancel configuring a key, by pressing the active Device Selector key before the learn process is
complete; the Learn LED will turn red.
Example: Learning "VCR Pause"
Position the HTR L76 and your VCR player's remote as described above.
• On the HTR L76, simultaneously press-and-hold "VCR" and ; the Learn LED turns steady
green.
• Press the HTR L76's (pause) key; the Learn LED turns amber.
• Press-and-hold the VCR player's remote's pause key; the HTR L76's Learn LED flickers amber and
then turns solid green. The command is learned.
• Press "VCR" again to exit the learning mode.
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA