Netac Tech T600 - Manual (Page 9)

Netac AirTrack T600 Mini Wireless Router
4
2 Quick Start
The Netac AirTrack T600 Mini Wireless Router (abbreviated to: T600) is configured through a website
protected by password. Table 2.1 lists the default IP address, user name, and password for T600
configuration website.
Table 2.1 Default Values
Parameter Default Value
IP Address 192.168.1.1
User name admin
Password password
The following steps set up T600 for immediate use:
1. Connect T600 with the computer through an Ethernet cable.
2. Plug in the 5V power supply.
3. Please ensure the IP address of your computer is on the 192.168.1.x subnet, such as 192.168.1.100.
4. Open a web browser and input "192.168.1.1", then press Enter.
5. Type "admin" for the user name field and "password" for the password.
6. The default operating mode is AP Router Mode. To switch to Repeater, P2P, PMP or Client Mode, go to
the Mode Selection page and select the desired mode, click Apply. T600 will reboot and enter the
selected mode.
7. After T600 reboots, go to the Mode Selection page and click Setup. Configure the applicable properties
for that mode, such as security, SSID, channel, and click Apply to take effect.
8. T600 is now ready to use.
2.1 Default Factory Settings
Restore the default factory settings by holding the "Reset" button for at least 10 seconds with T600 powered
on.