Netac Tech T600 - Manual (Page 13)

Netac AirTrack T600 Mini Wireless Router
8
3.4 Point-to-Multipoint (PMP) Mode
A T600 device operating in Point-to-Multipoint (PMP) Mode wirelessly connects two or more wired networks,
as shown in Figure 3.5. The root T600 device (LAN 1) operates in PMP Mode, and the other T600 devices
(LAN 2, LAN3) must operate in P2P Mode.
Figure 3.5 PMP Mode (Wireless Bridge)
When operating in PMP Mode, T600 device does not allow client connecting to it directly.
To configure T600 devices to establish a PMP wireless bridge, ensure the following:
1. Enter the MAC address of T600 P2P-1 device and T600 P2P-2 device in the Remote Bridge MAC
address field in T600 PMP device (on the PMP Mode Setup page, Figure 5.11).
2. Enter the MAC address of T600 PMP device in the Remote Bridge MAC address field in T600 P2P-1
device and T600 P2P-2 device (on the P2P Mode Setup page, Figure 5.8).
Section 5.4 "PMP Mode Setup Page" describes the configuration details for this mode.
3.5 Client Mode
When T600 operate in Client Mode, T600 device associates to an AP within its range in infrastructure mode,
as shown in Figure 3.6, or joins with another Client Mode T600 device in an Ad-Hoc network, as shown in
Figure 3.7. In Client Mode, T600 operates as a normal wireless client.