Netac Tech T600 - Manual (Page 23)

Netac AirTrack T600 Mini Wireless Router
18
l To set up the Repeater, the user must enter the MAC address of the Parent AP/Router/Repeater which
this Repeater is connected in the Parent MAC Address field.
l To link an additional repeater, the user must enter the MAC address of the additional repeater in the
Child MAC Address field.
5.2.1 Repeater Mode - Security Configuration
To enable security, select the desired security mode (WEP or WPA) in the Repeater Mode setup page (Figure
5.7) and click the Setup button to enter the configuration page. Under Repeater Mode, you must make sure
the security configuration of AP and Network Card are consistent with Repeater in order to communicate with
each other.
5.2.1.1 WEP Configuration Page
The Repeater Mode WEP Configuration page is identical to the one for AP Router Mode. Refer to Figure 5.3,
"AP Router Mode - WEP Configuration Page" for the details.
Table 5.7 details the WEP configuration.
Table 5.7 Repeater Mode - WEP Configuration
Field Description
WEP Length Select WEP key length: 64 bits or 128 bits.
Mode Select WEP key format: Hexadecimal or ASCII.
Passphrase
Passphrase is used to generate the WEP keys. Click the Generate button to
generate the keys. Click the Clear button to clear the Passphrase field.
Key 1-4 WEP keys.
Default key Select default WEP key from Keys1-4.
5.2.1.2 WPA Configuration Page
The Repeater Mode WPA Configuration page is identical to the one for AP Router Mode. Refer to Figure 5.4,
"AP Router Mode - WPA Configuration Page" for the details.
Table 5.8 details WPA configuration.
Table 5.8 Repeater Mode - WPA Configuration
Field Description
Authentication Use PSK (Pre-Shared Keys) authentication only.