Nokia 2112 - Manual (Page 45)

S e t t i n g s ( M e n u 4 )
36 Copyright © 2004 Nokia. All rights reserved.
4. Press the End key to return to the
standby screen; then enter the
phone number, including any
prefix (such as 0 or 1), that your
calling card may require when
you make a calling card call.
See your calling card for
instructions.
5. Press and hold the Send key for a
few seconds until Card call is
displayed.
6. When you hear the tone or
system message, press OK .
Data/fax calls
Data or fax calls is a Network
Service. See
"Network services" on
page viii for more information.
If your wireless service provider
supports this feature, then you can
set up the phone to send or receive
data or fax calls when a terminal,
such as a PDA or PC, is connected.
For better performance during data
calls, place the phone on a
stationary surface. Do not move the
phone by holding it in your hand
during a data call.
Note: For more information
on connectivity, refer to the
PC/PDA Connectivity Guide.
The PC/PDA Connectivity
Guide can be downloaded
from the Nokia website at
www.nokia-asia.com.
1. At the standby screen, select
Menu > Settings > Call settings >
Data/fax calls > Incoming
data/fax call > Normal , Data calls
only , or Fax calls only and press
Select :
Normal — The phone receives
incoming calls as usual.
Data calls only — The phone
receives only data calls.
Fax calls only — The phone
receives only fax calls.
2. When you are finished receiving
the fax or data call, repeat Steps
1 and 2 and select
Normal .
Data transfer
You can view the transmission speed
when sending or receiving data or
fax calls.
At the standby screen, select Menu >
Settings > Call settings > Data/fax
calls > Data rate display > Graphic or
Off and press Select .
Call Summary
Your phone can display the time
spent on a call when you hang up.
At the standby screen, select Menu >
Settings > Call settings > Call
summary > On or Off .