Eizo T57S - Manual (Page 31)

E
31
7 TROUBLESHOOTING
• Error messages will remain on the screen for 30 seconds, and then disappear. An
error message may not appear at all if the signal frequency is extremely high or
extremely low.
• Check that the PC is switched ON.
• Check that the signal cable is properly connected to
the graphics board or PC.
• Check that the graphics board is correctly inserted
in the PC.
• Switch the signal input by pushing the BNC/ D-Sub
selection button on the front control panel.
• Use the graphics board’s utility software to change
the frequency setting. (Refer to the manual of the
graphics board.)
• Whenever an error signal message appears, the
signal frequency will be displayed in red.
• Press the AUTO-SIZING button on the front panel.
See Quick Setup Guide, page 8.
• Adjust the image size and/or position using the
icons in the ScreenManager 'Screen' menu. See
page 9.
• Use of the “moiré reduction” feature may cause a
slight vibration. To eliminate the vibration, switch
the feature OFF or reduce the moiré reduction level.
See page 10.
• Check that the signal cable is properly connected to
the graphics board or PC.
• Check that the graphics board is correctly mounted
in the PC.
4) “No signal detected” error
message appears.
5) “Out of range” error
message appears.
(Example)
Imaging problems
1) Display size and/or position
is incorrect.
2) • The image vibrates on the
screen.
• A slight shaking movement
of the screen image or
text.