Input priority – Eizo T57S User Manual
Page 23
E
23
5 OTHER SETTINGS
Input Priority
This unique feature of the ScreenManager is for those users who utilize
two PCs. It allows the user to set the priority on the PC of choice.
The monitor automatically detects the selected 'Input Priority' setting
every time the power is turned ON (see note). Once the priority is set,
whenever a signal is detected at that connection, the monitor will convert
to that signal and display the data being sent.
There are three settings available: D-Sub, BNC or Manual. Since the
monitor comes with a standard D-Sub cable, the default priority setting
is set to D-Sub.
If only a single PC is connected and the standard bundled cable is used,
no special setting is required.
How to use
Use this function to select which of two connected PCs controls the
monitor. The following table indicates the available selections. For
additional information, refer to "Getting the Most from your Monitor"
on page 27.
Priority setting
Performance
D-Sub
The monitor automatically detects and displays
signals received from the D-Sub or BNC input.
If signals from both inputs are present, the monitor
displays the D-Sub signal.
BNC
The monitor automatically detects and displays input
signals received at the BNC or D-Sub input.
If signals from both inputs are present, the monitor
displays the BNC signal.
Manual
The monitor does not detect signals automatically.
Select the active input by pressing the BNC/D-Sub
selection button on the monitor's front panel.
•
The ScreenManager priority setting can be overridden at any time by
using the BNC/D-Sub selection button on the front panel. Priority
selection will be restored when the PC or monitor is switched ON
again.