Napoleon Fireplaces Vittoria GD19P - Manual (Page 27)

27
W415-0612 / C / 01.25.08
Randomly place the charcoal embers along the front and
sides of the burner in a realistic manner. Fine dust found in
the bottom of the bag should not be used.
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to be
placed on the burner ports.
Tear the embers into pieces and place along the burner ports
covering all of the burner. Care should be taken to shred the
embers into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow. The ember material will only
glow when exposed to direct fl ame; however, care should be
taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition. Phazer
TM logs glow
when exposed to direct fl ame. Use only certifi ed "glowing
embers" and Phazer
TM logs available from your Napoleon®
dealer.
CHARCOAL EMBERS
LOGO PLACEMENT
GLOWING EMBERS
VERMICULITE
Remove the backing of the
logo supplied and place on
the glass viewing door, as
indicated.
FIGURE 61
CONTROL FUNCTIONS
MAIN
BURNER
SWITCH
NIGHT
LIGHT TM
SWITCH
FLAME
ADJUSTMENT
FAN
CONTROL
(OPTION)
MAIN BURNER SWITCH
FLAME ADJUSTMENT
NIGHT LIGHT TM SWITCH
FAN CONTROL OPTION
This switch turns the Main Burner on and off.
Turn this knob clockwise or counter-clockwise to adjust the
main burner fl ame height.
This switch turns the Night Light TM on and off.
If installed this switch will turn on and off the power to the
blower and control the fan speed. There is also a thermally
activated switch that will only let the blower come on once
the unit has reached a comfortable temperature.
FIGURE 62
LOGO
1 /
2
"
1 /
2
"
3. Place the center log as shown, ensuring the holes on the
underside are placed onto the two center pins.
4. Place the hole in the underside of the right log onto the
locating pin, on the burner base and rests against the rear
log as shown.
5. Re-install the glass door.