7) optimizing computer signal automatically, Adjusting the image using auto adjust, Optimizing computer signal automatically – NEC M350X User Manual
Page 36
26
2. Projecting an Image (Basic Operation)
Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
Optimizing a computer image automatically. (COMPUTER1/COMPUTER2)
Press the AUTO ADJ. button to optimize a computer image automatically.
This adjustment may be necessary when you connect your computer for the first time.
[Poor picture]
[Normal picture]
NOTE:
Some signals may take time to display or may not be displayed correctly.
• If the Auto Adjust operation cannot optimize the computer signal, try to adjust [HORIZONTAL], [VERTICAL], [CLOCK], and [PHASE]
manually. (
Turning Up or Down Volume (not available on M420XV)
Sound level from the speaker can be adjusted.
TIP: When no menus appear, the
and buttons on the projector cabinet work
as a volume control.
NOTE:
• Volume control is not available with the
or button when an image is enlarged
by using the D-ZOOM (+) button or when the menu is displayed.
• Volume control is not available with the
or button when VIEWER is
used.
TIP: The [BEEP] sound volume cannot be adjusted. To turn off the [BEEP] sound,
from the menu, select [SETUP]
→ [OPTIONS (1)] → [BEEP] → [OFF].
Increase volume
Decrease volume