Power Sentry COMPASS 4 - Manual (Page 18)

Newpoint Technologies, Inc. COMP-USER-006
Salem, NH 03079 Rev. 3.2 –01/31/01 18
Hardware Requirements & Recommended Settings
Processor
Pentium II 233 MHz
(see note below) Memory
(RAM) at least 96
MB
Hard Drive
at least 300MB free
space available for a
complete installation
Medium
CD-ROM
drive
Mouse
Use a three-button mouse to take advantage of all
navigation features in Newpoint Compass.
(A two-button mouse is acceptable)
Display
SVGA monitor, that can support 65536 Colors, Small
Fonts Enabled, and 1024 x 768 resolution.
Plus!
We recommend that you disable the option to Show
window contents while dragging. This setting is
located in the Display Properties page on the
Windows NT Control Panel.
Operating
System
IMPORTANT!!
Newpoint Compass operates on the Windows NT
(4.0+) platform exclusively. Windows NT Server or
Workstation must be installed on your PC before you
install Newpoint Compass. Networking functionality
must be present, even if you plan to use Newpoint
Compass on a single, stand-alone system.
File
System
IMPORTANT!!
Compass should be installed over an NTFS file
system. The FAT32 file system can not provide as
secure an installation as the NTFS file system.
Network
Protocol
IMPORTANT!!
TCP/IP must be resident on the system to which you
are loading Compass. If the installation process can
not detect this protocol, the process is halted and a
pop-up window reports the problem. Refer to
Windows NT documentation for instructions to load
TCP/IP to your machine.