NEC MultiSync LT 80 User Manual
Page 22

Settings for Monitor Mode
Number of DIP switch
Monitor size
15” multi-scan mode /16”–13”
17” multi-scan mode /19”–13”
19” multi-scan mode /21”–13”
13” fixed mode /640
ן480
VGA/SVGA mode
16” fixed mode /832
ן624
19” fixed mode /1024
ן768
41
INSTALLATION
42
S1
ON
ON
ON
ON
S2
S3
S4
ON
S5
ON
ON
S6
ON
S7
ON
S8
ON
NOTE: For setting other than display modes supported by your Macintosh and LT80, using of the DIP
switch may bounce a image slightly or may display nothing. If this happens, set the DIP switch to the 13”
fixed mode and then restart your Macintosh. After that, restore to a displayable mode and then restart the
Macintosh again.
Make sure that LT80 and your Macintosh are connected with the monitor adapter and the supplied signal
cable (mini D-Sub 15-pin connector) and then restart your Macintosh.
NOTE: Refer to your computer's owner's manual for more information about your computer's video
output requirements and any special identification or configuring your projector's image and monitor
may require.
ON
→
1 2 3 4 5 6 7 8
ON
→
1 2 3 4 5 6 7 8
ON
→
1 2 3 4 5 6 7 8
13” fixed mode
17” multi-scan mode
VGA/SVGA mode
Examples of DIP switch setting