beautypg.com

Installation, Line level audio inputs, Cascade audio outputs – Niles Audio SI-1260 User Manual

Page 17: Ac power plug, Inst alla tion

background image

16

INSTALLATION

Line Level Audio Inputs

Caution!

The amplifier must be off whenever you make changes to the input con-

nections.

Cascade Audio Outputs

The "Cascade Audio Outputs" enable you to connect additional amplifiers to your
preamplifier's output. Connection is accomplished with standard RCA interconnect
cables. The outputs are not buffered; to daisy chain more than five Niles amplifiers
you will need a Niles AVDA-3 buffered distribution amplifier. A single AVDA-3
enables you to daisy chain five amplifiers from each of three outputs. This allows 15
SI-1260 power amplifiers to be fed from the same master preamplifier. If your pre-
amplifier has a vacuum tube output stage, you must use a Niles AVDA-3 to drive
more than one SI-1260.

AC Power Plug

STEP

1. Correctly label the interconnecting

cables coming from each source.

2. Connect the sources by inserting the

RCA connectors into a BusMatrix

input or dedicated input jack on the
SI-1260's rear panel.

NOTE: When you are using two ampli-
fier channels in the "bridged" mode,
assign the audio signal to be ampli-
fied to the EVEN numbered amplifier
channel using the BusMatrix

Dip

Switches.

DESCRIPTION

Use audio patch cables terminated with
RCA connectors.

Connect outputs from your source compo-
nents to the input jacks on the amplifier.
NEVER connect a preamplifier or source
input (e.g., record inputs) to the SI-1260
inputs.

STEP

1. Plug the SI-1260’s attached 2 prong
power cord into a correctly grounded
120 Volt, 60-Hz wall outlet.

CAUTION! DO NOT PLUG THE SI-1260'S
POWER CORD INTO A PREAMPLIFI-
ER'S CONVENIENCE OUTLET.

DESCRIPTION

If you use a grounded power strip, surge
protector, or extension cord, verify that the
proper ground is maintained

1. The SI-1260 draws a maximum of about

890 watts from an AC wall outlet. This is
much more than the typical accessory
outlet on a component's rear panel can
provide.

2. Use the SI-1260's auto turn-on circuitry

to switch "ON" the SI-1260 when the
preamplifier is "ON".

INST

ALLA

TION