beautypg.com

Install the cfp-20xx controller on the backplane, Install the cfp-20 xx controller on the backplane – National Instruments cFP-20xx User Manual

Page 10

background image

cFP-20xx Quick Start Guide

10

ni.com

2. Install the cFP-20xx Controller on the Backplane

1. Make sure that no power is connected to the controller.

2. Make sure that the cFP-20xx controller is right side up with the NI logo at

the top, and align the captive screws on the controller with the holes on the
backplane.

3. Seat the card edge at the back of the controller in the card-edge connector on

the backplane.

4. Press the controller firmly to seat it on the backplane.

5. Using a number 2 Phillips screwdriver with a shank of at least 64 mm (2.5 in.)

length, tighten the captive screws to 1.1 N · m (10 lb · in.) of torque.

See also other documents in the category National Instruments Hardware: