NetComm V110 - Manual (Page 60)

�11��� ��1���� ��11�� ���� User Guide YML881Rev1
� www.netcomm.com.au
IVr Interface for VoIP Gateway
You can use the PSTN phone to configure the NetComm ATA. Please follow the instruction below to configure it.
Group IVr Action IVr menu choice Parameter(s) notes:
Function Reboot #195# None After you hear “Option
Successful,” hang-up. The
system will reboot automatically.
Function Factory Reset #198# None System will automatically
Reboot. WARNING: ALL “User-
Changeable” NON DEFAULT
SETTINGS WILL BE LOST! This
will include network and service
provider data.
Info Check IP Address #120# None IVR will report the LAN port IP
address
Info Check IP Type #121# None IVR will report the WAN Port
DHCP is enabled or disabled.
Info Check the Phone
Number #122# None IVR will report the VoIP number
in use.
Info Check Network
Mask #123# None IVR will report the WAN Port
network mask
Info Check Primary DNS
Server Setting #125# None IVR will announce the current
setting in the Primary DNS field.
Info Check IP Address #126# None IVR will report the WAN port IP
address
Info Check Firmware
Version #128# None IVR will announce the version of
the firmware running on the VoIP
Gateway.
Setting Set DHCP client #111# None The system will change to DHCP
client type
Setting Set Static IP Address #112xxx*xxx*xxx*xxx# Enter IP address using
numbers on the telephone key
pad. Use the *(star) key when
entering a decimal point.
DHCP will be disabled and
system will change to the Static
IP type.
Setting Set Network Mask #113xxx*xxx*xxx*xxx# Must set Static IP first.
Setting Set Gateway IP #114xxx*xxx*xxx*xxx# Must set Static IP first.
Setting Set Primary DNS
Server #115xxx*xxx*xxx*xxx# Must set Static IP first.
Setting Set Codec #130+[1-8]# 1:G.711 u-Law, 2: G.711 a-
Law, 3:G.723.1, 4: G.729a, 5:
G.726 16K, 6:G.726 24K, 7:
G.726 32K, 8: G.726 40K, You can set the codec you want
to the first priority.
Set Handset Gain #131+[00~15]# Handset Gain from 0~15 You can set the Handset gain to
proper value, default is 6
Set Handset Volume #132+[00~12]# Handset Volume from 0~12 You can set the Handset volume
to proper value, default is 10