NEC LT20 - Manual (Page 32)

28 English ...
Replacing the lamp
The projector will detect the lamp life itself. It will show
you a warning message “The lamp has reached the end of its
usable life. Please replace the lamp.” When you see this
message, change the lamp as soon as possible.
Make sure the projector has been cooled down for at least
60 minutes before changing the lamp.
Warning: Lamp
compartment is hot!
Allow it to cool down
before changing lamp!
Lamp Changing Procedure:
1. Switch off the power to the projector by pressing the On/
Standby button.
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the 2 screws from the cover.n
5. Push up and remove the cover.o
6. Remove the 2 screws from the lamp module.p
7. Pull out the lamp module. q
To replace the lamp module, reverse the previous steps.
Warning: To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp
bulb. The bulb may
shatter and cause
injury if it is dropped.
1 3
4
Appendices
2